Emiter IST-REG-24V-1000W Hybrid Charge Controller (24 V, 1000 W)

The Emiter IST-REG-24V-1000W hybrid charge controller is designed for systems combining a wind turbine up to 1000 W and photovoltaic panels up to 600 W in 24 V battery installations. The device is based on electronic components without the use of electromechanical relays, which increases its reliability and extends its lifespan.

The Emiter hybrid controller allows for the simultaneous connection of a three-phase permanent magnet wind turbine and solar panels to a 24 V battery bank. The entire circuit is housed in a high mechanical strength metal enclosure that effectively dissipates heat. The turbine braking process occurs automatically if excessive rotational speed or high temperature is detected. A manual brake switch is also available to facilitate safe load disconnection.

Key features

• Supports wind turbines up to 1000 W and PV modules up to 600 W.
• No electromechanical relays in the internal design.
• Reverse polarity protection and a built-in fuse.
• Operating status indicated by two LEDs (yellow and red).
• Soft turbine braking function to prevent mechanical shocks.

Technical data

Nominal system voltage	24 V
Maximum wind turbine power	1000 W
Maximum solar panel power	600 W
Maximum charge current	40 A
Charge start voltage	24.5 V
Charge end voltage	28.5 V
Maximum input voltage	60.0 V
Recommended battery cable cross-section	6 mm²
Maximum distance from battery	3 m
Maximum turbine rotational speed	1500 rpm